Pall Sterile Cord Blood Collection Unit: Package Insert and Label Information

PALL STERILE CORD BLOOD COLLECTION UNIT- dextrose monohydrate, sodium citrate, citric acid monohydrate and sodium phosphate, monobasic, monohydrate solution
Pall Corporation

ANTICOAGULANT CITRATE PHOSPHATE DEXTROSE SOLUTION (CPD)

Sterile, non-pyrogenic fluid path. Sterilized by steam.

This product is free of natural rubber latex.

Indications and Usage Section

For collection of up to 210 ml of umbilical cord blood. Use aseptic technique.

Contents inside overwrap pouch, within the foil envelope, are sterile and acceptable for use in a sterile field if pouch is unopened and undamaged; visual inspection to confirm the integrity of overwrap pouch should be performed.

Warnings Section

Making multiple punctures of the umbilical cord to increase collection volume may increase the risk of contamination.

Do not irradiate collected cord blood or components.

GENERAL PRECAUTIONS

Do not use if the package is damaged or seal is incomplete. Use only if solution is clear.
Sealing should be done in a manner that avoids fluid splatter.

Always dispose of blood-contaminated products in a manner consistent with established BIOHAZARD safety procedures.

HOW SUPPLIED

The Collection Unit inside the overwrap pouch, within the foil envelope, are sterile and acceptable for use in a sterile field if pouch is unopened and undamaged.

INFORMATION FOR PATIENTS

Visit us at www.pall.com/medical

For Pall customer service, call: 1.800.645.6578

DonorCare is a registered trademark of ITL Corporation, Canberra, Australia. Produced under license from ThermoGenesis Corp

  1. Ensure DonorCare® Needle Guard (DCNG) is positioned on the tubing between the needle hub and Pinch Clamp. Engage Pinch Clamp. Ensure tethered cap is placed securely on the air vent.
  2. Using aseptic technique, insert needle into umbilical vein, disengage Pinch Clamp to collect cord blood, mixing frequently, according to standard procedures.
  3. Upon completion of collection, engage Pinch Clamp then withdraw needle from umbilical vein. Slide the DCNG midway over the needle hub. While holding the sides of DCNG near front, grasp tubing and pull smoothly, pulling needle into the DCNG until it locks into place. Confirm that needle is locked by listening for the second click as the needle is drawn into the DCNG. Ensure that tubing cannot be pulled through DCNG.
  4. Place the bag on a work surface. While holding the tubing above the bag, open the tethered cap on the air vent. Allow the blood to drain from the tubing into the bag.
  5. When the tubing has been drained, hold tubing vertical and seal tubing directly below the Y-piece with air vent.
  6. Detach and discard needle, DCNG, Pinch Clamp, Air Vent and tubing according to standard procedures.
  7. Determine amount of anticoagulated blood collected. If required, add sedimenting agent to CPD anticoagulated blood through Sample Port using a syringe according to standard procedures.
  8. Mix well. Take care to strip and mix any blood in tubing.
  9. Load bag into centrifuge cup. It is suggested that a means of support is used to prevent bag from collapsing and to reduce wrinkles.
  10. Centrifuge according to standard procedures to obtain mononuclear cell-rich plasma.

Bag Label
(click image for full-size original)
Printed Pouch Label
(click image for full-size original)

Case Label
(click image for full-size original)
IFU
(click image for full-size original)
PALL STERILE CORD BLOOD COLLECTION UNIT
sterile cord blood collection unit solution
Product Information
Product Type HUMAN PRESCRIPTION DRUG Item Code (Source) NDC:79403-791
Route of Administration INTRAVENOUS DEA Schedule
Active Ingredient/Active Moiety
Ingredient Name Basis of Strength Strength
DEXTROSE MONOHYDRATE (ANHYDROUS DEXTROSE) DEXTROSE MONOHYDRATE 0.893 g in 35 mL
SODIUM CITRATE (ANHYDROUS CITRIC ACID) SODIUM CITRATE 0.921 g in 35 mL
CITRIC ACID MONOHYDRATE (ANHYDROUS CITRIC ACID) ANHYDROUS CITRIC ACID 0.114 g in 35 mL
SODIUM PHOSPHATE, MONOBASIC, MONOHYDRATE (PHOSPHATE ION) SODIUM PHOSPHATE, MONOBASIC, MONOHYDRATE 0.0078 g in 35 mL
Inactive Ingredients
Ingredient Name Strength
WATER 35 g in 35 mL
PHOSPHORIC ACID
Packaging
# Item Code Package Description Multilevel Packaging
1 NDC:79403-791-01 35 mL in 1 BAG None
Marketing Information
Marketing Category Application Number or Monograph Citation Marketing Start Date Marketing End Date
NDA BN800222 03/16/2011
Labeler — Pall Corporation (002054419)
Establishment
Name Address ID/FEI Operations
Haemonetics Manufacturing Inc. 078598396 manufacture (53157-791)

Revised: 01/2022 Pall Corporation

DrugInserts.com provides trustworthy package insert and label information about marketed drugs as submitted by manufacturers to the US Food and Drug Administration. Package information is not reviewed or updated separately by DrugInserts.com. Every individual package label entry contains a unique identifier which can be used to secure further details directly from the US National Institutes of Health and/or the FDA.

As the leading independent provider of trustworthy medication information, we source our database directly from the FDA's central repository of drug labels and package inserts under the Structured Product Labeling standard. Our material is not intended as a substitute for direct consultation with a qualified health professional.

Terms of Use | Copyright © 2023. All Rights Reserved.