BACITRACIN- bacitracin a injection, powder, for solution
To reduce the development of drug-resistant bacteria and maintain the effectiveness of bacitracin for injection and other antibacterial drugs, bacitracin for injection should be used only to treat or prevent infections that are proven or strongly suspected to be caused by bacteria.
For Intramuscular Use
Nephrotoxicity: Bacitracin in parenteral (intramuscular) therapy may cause renal failure due to tubular and glomerular necrosis. Its use should be restricted to infants with staphylococcal pneumonia and empyema when due to organisms shown to be susceptible to bacitracin. It should be used only where adequate laboratory facilities are available and when constant supervision of the patient is possible.
Renal function should be carefully determined prior to and daily during therapy. The recommended daily dose should not be exceeded and fluid intake and urinary output should be maintained at proper levels to avoid kidney toxicity. If renal toxicity occurs the drug should be discontinued. The concurrent use of other nephrotoxic drugs, particularly streptomycin, kanamycin, polymyxin B, polymyxin E (colistin), and neomycin should be avoided.
Bacitracin for Injection, USP is a sterile antibiotic for intramuscular administration. Bacitracin is derived from cultures of Bacillus subtilis (Tracey). It is a white to pale buff, hygroscopic powder, odorless or having a slight odor. It is freely soluble in water; insoluble in acetone, chloroform, and ether. While soluble in alcohol, methanol, and glacial acetic acid, there is some insoluble residue. It is precipitated from its solutions and inactivated by many of the heavy metals.
The structural formula is:
The molecular formula is: C66 H103 N17 O16 S. Bacitracin is comprised of a polypeptide complex and bacitracin A is the major component in this complex. The molecular weight of bacitracin A is 1422.71.
Bacitracin exerts pronounced antibacterial action in vitro against a variety of gram-positive and a few gram-negative organisms. However, among systemic diseases, only staphylococcal infections qualify for consideration of bacitracin therapy. Bacitracin is assayed against a standard and its activity is expressed in units, 1 mg having a potency of not less than 50 units.
Susceptibility plate testing: If the Kirby-Bauer method of disk susceptibility is used, a 10 unit bacitracin disk should give a zone of over 13 mm when tested against a bacitracin-susceptible strain of Staphylococcus aureus. Absorption of bacitracin following intramuscular injection is rapid and complete. A dose of 200 or 300 units/kg every 6 hours gives serum levels of 0.2 to 2 mcg/mL in individuals with normal renal function. The drug is excreted slowly by glomerular filtration. It is widely distributed in all body organs and is demonstrable in ascitic and pleural fluids after intramuscular injection.
In accordance with the statements in the “Warning Box“, the use of intramuscular Bacitracin for Injection, USP is limited to the treatment of infants with pneumonia and empyema caused by staphylococci shown to be susceptible to the drug.
To reduce the development of drug-resistant bacteria and maintain the effectiveness of Bacitracin for Injection, USP and other antibacterial drugs, Bacitracin for Injection, USP should be used only to treat or prevent infections that are proven or strongly suspected to be caused by susceptible bacteria. When culture and susceptibility information are available, they should be considered in selecting or modifying antibacterial therapy. In the absence of such data, local epidemiology and susceptibility patterns may contribute to the empiric selection of therapy.
This drug is contraindicated in those individuals with a history of previous hypersensitivity or toxic reaction to it.
Clostridium difficile associated diarrhea (CDAD) has been reported with use of nearly all antibacterial agents and may range in severity from mild diarrhea to fatal colitis. Treatment with antibacterial agents alters the normal flora of the colon leading to overgrowth of C. difficile.
C. difficile produces toxins A and B which contribute to the development of CDAD. Hypertoxin producing strains of C. difficile cause increased morbidity and mortality, as these infections can be refractory to antimicrobial therapy and may require colectomy. CDAD must be considered in all patients who present with diarrhea following antibacterial use. Careful medical history is necessary since CDAD has been reported to occur over two months after the administration of antibacterial agents.
If CDAD is suspected or confirmed, ongoing antibacterial use not directed against C. difficile may need to be discontinued. Appropriate fluid and electrolyte management, protein supplementation, antibacterial treatment of C. difficile , and surgical evaluation should be instituted as clinically indicated.
See “Warning Box” for precautions in regard to kidney toxicity associated with intramuscular use of bacitracin.
Adequate fluid intake should be maintained orally, or if necessary, by parenteral method.
As with other antibiotics, use of this drug may result in overgrowth of nonsusceptible organisms, including fungi. If superinfection occurs, appropriate therapy should be instituted.
Prescribing bacitracin in the absence of a proven or strongly suspected bacterial infection or a prophylactic indication is unlikely to provide benefit to the patient and increases the risk of the development of drug-resistant bacteria.
There have been reports of anaphylaxis and/or allergic contact dermatitis in patients exposed to bacitracin for injection in non-approved indications.
Patients should be counseled that antibacterial drugs, including bacitracin, should only be used to treat bacterial infections. They do not treat viral infections (e.g., the common cold). When bacitracin for injection is prescribed to treat a bacterial infection, patients should be told that although it is common to feel better early in the course of therapy, the medication should be taken exactly as directed. Skipping doses or not completing the full course of therapy may (1) decrease the effectiveness of the immediate treatment and (2) increase the likelihood that bacteria will develop resistance and will not be treatable by bacitracin for injection or other antibacterial drugs in the future.
Diarrhea is a common problem caused by antibacterial drugs which usually ends when the drug is discontinued. Sometimes patients can develop watery and bloody stools (with or without stomach cramps and fever) even as late as two or more months after having taken the last dose of the antibacterial drug. If this occurs, patients should contact their physician as soon as possible.
Nephrotoxic reactions —Albuminuria, cylindruria, azotemia. Rising blood levels without any increase in dosage.
Other reactions —Nausea and vomiting. Pain at site of injection. Skin rashes.
TO BE ADMINISTERED INTRAMUSCULARLY ONLY
Infant dose: For infants under 2500 grams—900 units/kg/24 hours in 2 or 3 divided doses. For infants over 2500 grams—1,000 units/kg/24 hours, in 2 or 3 divided doses. Intramuscular injections of the solution should be given in the upper outer quadrant of the buttocks, alternating right and left and avoiding multiple injections in the same region because of the transient pain following injection.
Should be dissolved in sodium chloride injection containing 2 percent procaine hydrochloride. The concentration of the antibiotic in the solution should not be less than 5,000 units per mL or more than 10,000 units per mL.
Diluents containing parabens should not be used to reconstitute bacitracin; cloudy solutions and precipitate formation have occurred. Reconstitution of the 50,000 unit vial with 9.8 mL of diluent will result in a concentration of 5,000 units per mL.
Solutions are stable for one week when stored in a refrigerator 2° to 8°C (36° to 46°F).
Bacitracin for Injection, USP is available in a vial containing 50,000 units bacitracin.
NDC 17478-608-30 Carton of 1 vial
Store the unreconstituted product in a refrigerator 2° to 8°C (36° to 46°F).
Lake Forest, IL 60045
BC00N Rev. 10/17
Principal Display Panel Text for Container Label:
for Injection, USP
50,000 Units Per Vial
For Intramuscular Use
Principal Display Panel Text for Carton Label:
for Injection, USP
50,000 Units Per Vial
For Intramuscular Use
1 x 50,000 Unit Vial
Rx only Akorn Logo
| BACITRACIN |
bacitracin injection, powder, for solution
|Labeler — Akorn, Inc. (117696770)|
|Registrant — Akorn Operating Company LLC (117693100)|
|Akorn, Inc||117696790||PACK (17478-608), LABEL (17478-608)|
|Akorn, Inc.||117696832||MANUFACTURE (17478-608), ANALYSIS (17478-608), STERILIZE (17478-608)|
Revised: 10/2020 Akorn, Inc.
DrugInserts.com provides trustworthy package insert and label information about marketed drugs as submitted by manufacturers to the US Food and Drug Administration. Package information is not reviewed or updated separately by DrugInserts.com. Every individual package label entry contains a unique identifier which can be used to secure further details directly from the US National Institutes of Health and/or the FDA.